Expert Water Bill Audit Services

A water audit establishes how much water you are being billed for, how the meter is configured, and whether system conditions are inflating the reading. Water Flow Innovations focuses specifically on meter over-registration during demand surges, when water speeds up through the meter, pressure inside it drops, dissolved gas comes out of solution and vapor forms, and the meter counts that volume as water. The output is a quantified savings opportunity and a determination of whether a Flow Conditioning Device can reduce both the water charge and the sewer charge calculated from it.

It starts with a remote review of recent water and sewer bills, facility profile, meter size, pipe size, line pressure, and PRV configuration, together with your water-use patterns. Water Flow Innovations then assesses over-reading potential and prioritizes the highest-consumption utility service meters. Where savings are projected, an FCD is installed immediately after the meter in about an hour, with the water off for about an hour. Savings start on the next full billing cycle and are verified against subsequent bills.

High bills can come from leaks, rate changes, or real increases in use, so those are checked first. Where they are ruled out, meter over-registration during demand surges is the next thing to check: many facilities run several high-frequency demand sources on one supply meter, and every demand event sends a surge through the meter. As water speeds up, pressure inside the meter drops, gas and vapor form, and the meter counts that volume as water. Cooling towers, irrigation cycling, CIP systems, tank fills, wash-down schedules, and rapid on-off operations are common surge sources, and they compound. Since sewer charges are tied to metered water volume, the same over-reading inflates both lines, which is why bills can rise while production or occupancy holds steady.

Nothing. The facility-specific Water Bill Review and Savings Analysis is free and carries no commitment, and it is completed remotely from uploaded bills so no initial site visit is required. It examines your water and sewer billing, meter and pipe configuration, line pressure, PRV setup, and facility type to estimate potential savings and identify where an installation would deliver the strongest return. On-site visits, if requested, are billable under standard company policy.

Water Flow Innovations typically documents up to a 30% reduction in combined water and sewer costs across installations (46% is the highest documented, a rare case). Results vary with meter and pipe configuration, demand surges, and usage volume. Savings start on the next full billing cycle after installation, and 90% of customers reach full ROI in under 12 months.

Yes. The Flow Conditioning Device is sized to your pipe and meter, so no meter replacement is required. It installs on the main water line immediately after the meter, ahead of the PRV, and creates a small, controlled back-pressure that extends back through the meter, holding pressure up during demand surges so far less gas and vapor form and are counted. Pressure loss is under 0.8 psi across all flow conditions, so downstream equipment and operations see no practical change.

About 1 hour, with the water off for about 1 hour. A licensed plumber or mechanical contractor performs the work. For complex sites or multiple meters, the assessment comes first so installations can be sequenced by consumption volume and scheduled into planned maintenance windows or shift changes, keeping disruption to the brief shutoff at each connection.

Yes. Most utilities calculate sewer charges from the same metered water reading, so every gallon the meter over-registers is billed twice despite never entering a drain. The audit quantifies the combined water and sewer exposure, because correcting the reading at the meter reduces both charges on the same billing cycle.

Yes. A new meter in the same conditions behaves the same way: when your own pumps, wash-down cycles, tank fills, or on-off demand send surges through the meter, pressure inside it drops, and the gas and vapor that form are counted as water. Replacing the instrument does not change the conditions at the meter. It's not your meter. It's your pipes. The audit checks whether those surge conditions are present and, if they are, estimates what correcting the over-registration could recover.